How to install your frame
Before you start
Every canvas floating frame arrives with D-rings and picture wire already on the back. What else is in the box depends on what you're framing:
- Stretched canvas: steel mounting screws
- Thin panel or board: a tube of clear adhesive, and the shelf inside the frame is left unfinished in a few spots so the adhesive has raw wood to grip
You'll need: a soft surface to work on, like a towel or blanket, and a few playing cards or strips of paper to center the art. For a canvas, a screwdriver. For a panel, something light and flat to rest on top while the adhesive sets, like a book.
Stretched canvas
- Lay the frame face up on a soft surface.
- Set your canvas into the frame, face up, so it rests on the shelf inside.
- Slide cards or paper shims into the gap on each side until the shadow line is even all the way around.
- Drive the included screws through the back of the frame's shelf into the canvas's wood stretcher bars.
- Remove the shims and hang it by the wire.
About five minutes. The video above shows every step.
Thin panel or board
Canvas panels, hardboard, gessoed panels, flat wood panels, and aluminum composite are too thin to take a screw, so they go in with adhesive.
- Lay the frame face up on a soft surface.
- Put a dab of the included adhesive on each unfinished spot on the shelf inside the frame.
- Set your panel in, face up, onto the adhesive.
- Slide cards or paper shims into the gap on each side until the shadow line is even.
- Rest something light and flat on the panel to hold it down.
- Leave it for 24 hours, then remove the shims and hang it.
Work somewhere with fresh air while the adhesive sets. A panel install video is on the way.
Hanging
Hang the frame by its wire on a picture hook rated for the weight. Bigger frames are steadier on two hooks spaced apart.
Stuck on anything? Email me at andrew@atlaswoodcompany.com. I answer every message myself.